Cannot send mail via MAPI
Posted: Mon Jan 18, 2016 10:41 am
Hi,
I need help with information or suggestion about the following:
I`m using Mail Enable Enterprise Edition and Outlook 2013. Since now the setup was through POP3 and worked without problem. Now I wanted to try the MAPI connector in order to sync my calendar with other people or mobile device.
So I downloaded and installed the connector and re-setup one mailbox through the MAPI settings in Outlook using this link:
http://www.mailenable.com/MailEnable_Co ... utlook.pdf
So far I`m getting incoming mails but cannot send anything via the outlook client:
On the client side the error is : Failed to send message. SMTP server responded with:-.
On the server the message stays in the Inbound SMTP in status Spooling.
In the Message tracker the info is: Result: [Mail number] is waiting in the SMTP inbound message queue to be routed by the MTA Service. This most likely means that the MTA service has not had sufficient time to route the message.
Can someone help me what to change or do in order to get outgoing mail going and the sync working?
Thanks in advance!
I need help with information or suggestion about the following:
I`m using Mail Enable Enterprise Edition and Outlook 2013. Since now the setup was through POP3 and worked without problem. Now I wanted to try the MAPI connector in order to sync my calendar with other people or mobile device.
So I downloaded and installed the connector and re-setup one mailbox through the MAPI settings in Outlook using this link:
http://www.mailenable.com/MailEnable_Co ... utlook.pdf
So far I`m getting incoming mails but cannot send anything via the outlook client:
On the client side the error is : Failed to send message. SMTP server responded with:-.
On the server the message stays in the Inbound SMTP in status Spooling.
In the Message tracker the info is: Result: [Mail number] is waiting in the SMTP inbound message queue to be routed by the MTA Service. This most likely means that the MTA service has not had sufficient time to route the message.
Can someone help me what to change or do in order to get outgoing mail going and the sync working?
Thanks in advance!