MailEnable error 500

Raise/discuss any potential issues with MailEnable for consideration in project issue register.
Post Reply
Posts: 1
Joined: Fri Jun 14, 2019 4:45 am
Location: ... velopment/

MailEnable error 500

Post by Enntinalb » Wed Jun 19, 2019 7:24 am

Good morning folks.

I have a curious problem sending to one recipient this morning, it is a person I have mailed perfectly successfully in the past and I'm not getting the error with anyone else.

MailEnable: Message could not be delivered to some recipients.
The following recipient(s) could not be reached:

Recipient: []
Reason: 500 Line too long

(Email address protected)

I am sure this is generated at the receiving end, but I just want to make sure I am correctly ruling out MailEnable as anything to do with me. And then, I can try to work out what the hell is too long, and where the long thing might be.

Any information on this would be gratefully received.

Post Reply