Receive Warning After Install

Raise/discuss any potential issues with MailEnable for consideration in project issue register.
Post Reply
jelliott77
Posts: 3
Joined: Tue Jun 13, 2017 9:15 am

Receive Warning After Install

Post by jelliott77 » Sun Jun 07, 2020 3:45 pm

Hello,

Every time I have upgraded Mailenable over the past couple of releases, I get the following warning message:

Warning: Unable to configure registry access permissions. Mailenable services may have issues accessing the registry. You will need to run MEInstaller after this installation and manually configure WebMail.

After the installation completes, there are no apparent issues with the Mailenable server. All components function fine, including the webmail.

I was wondering if this is a known bug? Do I have anything to worry about? Am I not experiencing issues due to the fact that this is an upgrade and not a fresh install?

Any feedback would be appreciated.

Thanks!

MailEnable-Ian
Site Admin
Posts: 9162
Joined: Mon Mar 22, 2004 4:44 am
Location: Melbourne, Victoria, Australia

Re: Receive Warning After Install

Post by MailEnable-Ian » Tue Jun 16, 2020 1:33 am

Hi,

Not a known bug and more so permission issues when your running the installer. Are you logged into the server as an administrator? Try and run the installation file as administrator (I.e: run as administrator). Are you installing on a terminal services machine?
Regards,

Ian Margarone
MailEnable Support

Post Reply