configure smtp on a developer server / redirecting

For any other discussion relating to MailEnable.
Post Reply
ehorses
Posts: 3
Joined: Thu Dec 20, 2012 9:02 am

configure smtp on a developer server / redirecting

Post by ehorses » Thu Dec 20, 2012 9:09 am

Hello, we use Mailenable Enterprise on our live server.

My question:

We use the standard edition on our development server to test several things of our software.

Is it possible to stop delivering all outgoing mails (remote) and redirect them to a local postoffice ?
I didnt find any option in the smtp-configuartion.

Is there a solution for our problem ?

Thx for reply

MailEnable
Site Admin
Posts: 4441
Joined: Tue Jun 25, 2002 3:03 am
Location: Melbourne, Victoria Australia

Re: configure smtp on a developer server / redirecting

Post by MailEnable » Thu Dec 27, 2012 10:40 pm

There is no option to deliver all messages to a local postoffice (because its not typical scenario that would apply to mailservers in general).
You could just stop/disable the mail transfer agent and delete the messages from the queues (that will allow the SMTP connector to accept messages from your application, but will not route them to their destination domain.
Regards, Andrew

Post Reply