Hi Everyone
On the "General" tab of the SMTP properties box, there are two boxes entitled "Local domain name" and "Default mail domain name". I have discovered that whatever you put in those two boxes ends up in the headers of emails you send using the MailEnable SMTP relay. This gives the same values in the headers for all of the domain names you have defined in the "Post Offices" section. I am not sure of a clearly understandable way of asking this but Is there a way of giving each domain name in the "Post Offices" section there own values for these two boxes so that for each domain name in the "Post Offices" section, different values end up in the headers of emails sent using the MailEnable SMTP relay? (according to the domain name in the "From" header in the email being sent)
I hope you can understand the above question.
Thank you very much.
Kind regards
Tim
Different values in headers for different domain names
-
- Site Admin
- Posts: 9738
- Joined: Mon Mar 22, 2004 4:44 am
- Location: Melbourne, Victoria, Australia
Re: Different values in headers for different domain names
Hi,
You can only configure this using Postoffice IP bindings which is an exclusive feature to the Enterprise edition.
You can only configure this using Postoffice IP bindings which is an exclusive feature to the Enterprise edition.
Regards,
Ian Margarone
MailEnable Support
Ian Margarone
MailEnable Support
Re: Different values in headers for different domain names
Hi Ian
Thank you very much for your reply.
Kind regards
Tim
Thank you very much for your reply.
Kind regards
Tim