Hi
I have created a new list for around a dozen people. I noticed that replies to the welcome message did not identify the sender (as replies are due to go to the list address).
So I added a header which included the [ME_MEMBER_EMAIL] hoping that this would identify those who replied to threads.
Unfortunately that tag rendered the original poster of the message instead of the member who replied.
I am using V9.
Any suggestions or explanations available?
Regards
John
Listeserver Newbie
-
- Posts: 62
- Joined: Tue May 13, 2014 8:40 pm
Re: Listeserver Newbie
Update: When I chose to have the "Send From" in the General tab of the List Properties dialogue set to "list address - change envelope only" the sender is now clear on mail clients.
However, the header only appears in about 20% of the messages, and when it does appear, it still shows the original poster and not the sender of the reply.
The header message is set to
This a post to [ME_LIST], from [ME_MEMBER_EMAIL]
As I say, it only appears randomly.
Is this a case for upgrading to V10?
However, the header only appears in about 20% of the messages, and when it does appear, it still shows the original poster and not the sender of the reply.
The header message is set to
This a post to [ME_LIST], from [ME_MEMBER_EMAIL]
As I say, it only appears randomly.
Is this a case for upgrading to V10?