Listeserver Newbie

Discussion forum for Enterprise Edition.
Post Reply
privateland
Posts: 62
Joined: Tue May 13, 2014 8:40 pm

Listeserver Newbie

Post by privateland »

Hi
I have created a new list for around a dozen people. I noticed that replies to the welcome message did not identify the sender (as replies are due to go to the list address).

So I added a header which included the [ME_MEMBER_EMAIL] hoping that this would identify those who replied to threads.

Unfortunately that tag rendered the original poster of the message instead of the member who replied.

I am using V9.

Any suggestions or explanations available?

Regards
John

privateland
Posts: 62
Joined: Tue May 13, 2014 8:40 pm

Re: Listeserver Newbie

Post by privateland »

Update: When I chose to have the "Send From" in the General tab of the List Properties dialogue set to "list address - change envelope only" the sender is now clear on mail clients.

However, the header only appears in about 20% of the messages, and when it does appear, it still shows the original poster and not the sender of the reply.

The header message is set to

This a post to [ME_LIST], from [ME_MEMBER_EMAIL]

As I say, it only appears randomly.

Is this a case for upgrading to V10?

Post Reply