Hi,
We want to setup our MailEnable server as ingoing and outgoing Gateway for our Exchange servers. Please explain how to do this setup. For outbound emails we need to have different smart host as below :
- sender from domain1.com go to smart host 1
- sender from domain2.com go to smart host 2.
Regards,
PPerles
Domain sender based
-
- Site Admin
- Posts: 9738
- Joined: Mon Mar 22, 2004 4:44 am
- Location: Melbourne, Victoria, Australia
Re: Domain sender based
Hi,
Firstly ensure you running 9.51 Standard edition. To configure domain level outbound smart hosting navigate to the postoffice in the administration console and right click the postoffice name and select properties. Under the "General" tab you will see the section to specify the outbound smart host configuration details. For incoming mail you will need to make these change sin DNS so that the MX record for each domain points to the MailEnable server.
Firstly ensure you running 9.51 Standard edition. To configure domain level outbound smart hosting navigate to the postoffice in the administration console and right click the postoffice name and select properties. Under the "General" tab you will see the section to specify the outbound smart host configuration details. For incoming mail you will need to make these change sin DNS so that the MX record for each domain points to the MailEnable server.
Regards,
Ian Margarone
MailEnable Support
Ian Margarone
MailEnable Support
Re: Domain sender based
Hi,
I try your configuration but it doesn't work. I think because postoffice is based on domain of the recipient, not the sender. Please clarify.
Regards,
PPerles
I try your configuration but it doesn't work. I think because postoffice is based on domain of the recipient, not the sender. Please clarify.
Regards,
PPerles
-
- Posts: 15
- Joined: Fri Nov 17, 2006 12:14 am
Re: Domain sender based
Hello,
I have the same problem.
Did you find a solution for it?
Best
Joao
I have the same problem.
Did you find a solution for it?
Best
Joao