selective Smart Host

Discussion forum for Enterprise Edition.
Post Reply
Maur0V
Posts: 50
Joined: Thu May 09, 2013 10:26 am

selective Smart Host

Post by Maur0V »

Hi to all. I've a problem to send mail to a specific remote domain. The hoster of this domain, has blacklisted all the ip range of my provider.
I know it's a silly think, but internet is full of silly tecnician.
To bypass the problem, i would send via smart host, but just for this specific domain. It's possible to create an outgoing filter to make this job?
or it's possible to do in any other way?

MailEnable-Ian
Site Admin
Posts: 9738
Joined: Mon Mar 22, 2004 4:44 am
Location: Melbourne, Victoria, Australia

Re: selective Smart Host

Post by MailEnable-Ian »

Hi,

You can smart host outgoing mail at the postoffice level. Right click on the postoffice within the administration console and access the properties for the postoffice. Under the "General" tab you will find the section for "Smarthost all outbound email for the postoffice". You may not see this option depending what version of MailEnable your running as this was only introduced in version 9.x on wards.
Regards,

Ian Margarone
MailEnable Support

Maur0V
Posts: 50
Joined: Thu May 09, 2013 10:26 am

Re: selective Smart Host

Post by Maur0V »

Thank's Ian, but this will smarhost every single mail sent from the postoffice. I wish to smarthost only the mail sent to the specific domain that block me.
Is it possible?

Post Reply